| Date: | Thu, 24 Aug 2000 12:57:42 |
| Subject: | Re: i need help |
| From: | MrSackFace16@aol.com |
| Reply to author Post followup (list members only) Back to index Subscribe to the mailing list Unsubscribe from the list |
this goes for everyone that will ask this question. The two best ways to get
power from a moped are first to get a free flow exhaust (make sure your
carbuerator is putting out to the max of what the engine needs. Olderr
mopeds were always governed by the carbuerator.) The second best thing to do
is port it, if the exhaust and intake are bigger you gain more hp. A number
of other things to do are increase compression ratio slightly by sanding
cylinder head. either take your air filter off or cut a whole in it and duct
a scoop to force air into it. Then after you do all these things you will
have gaind more hp and torque and can get a sprocket with a few less teeth in
the back to increase top speed and will still have greater acceleration than
before. For example a tomos moped will do 33 mph stock. then after you
change the exhaust to a biturbo you it will do 45. Then with a port ini
addition to that you do about 47 but you will have much more power and
accelation. Then with the air filter and increased compression you will do
close to 50, but after all this your horsepowerr will have doubled and then
you can put a smaller sprocket in the back and have faster accerlation than
before any modification and have a top speed of around 60
| Reply to author Post followup (list members only) Back to index Subscribe to the mailing list Unsubscribe from the list |
