| Date: | Wed, 21 Jun 2000 10:03:55 |
| Subject: | Re: tomos 91 bullet a35 (NOT A3) |
| From: | Mike _____ |
| Reply to author Post followup (list members only) Back to index Subscribe to the mailing list Unsubscribe from the list |
turn the screw all the way in as tight as it goes and let me know what
happens. we can go from there
>From: JoeK282@aol.com
>Reply-To: moped@topica.com
>To: moped@topica.com
>Subject: Re: tomos 91 bullet a35 (NOT A3)
>Date: Wed, 21 Jun 2000 08:49:31 -0700
> >In a message dated 6/20/00 5:49:29 PM Pacific Daylight Time,
>JoeK282@aol.com
>writes:
> ><< Hi,
> i was riding my moped today and it was running great, it started
>first
> kick. when i got home i decided to lower the idle like a tiny bit, i
>turned
> the idle screw on the carb, then when i went to start it up again it did
>not
> start:( . So i was screwing around with the idle screw and i got it to
>idle
> but if i gun it, pull the throttle all the way down, it dies, but if i
>just
> go half throttle it works fine. Or when i had the screw in a different
> position, there was a sort of delay before it actually got going, there
>was
> no delay before. So basically all i touched was the idle screw, please
>tell
> me if this will be very expensive to fix. i new i should have never
>touched
> that screw.
> > THanks for your time,
> Joe >> > >so cananyone help me?
>list.
| Reply to author Post followup (list members only) Back to index Subscribe to the mailing list Unsubscribe from the list |
