 |
Message Index |  |
||
| Re: Moped Chain | Tony Weinfurtner |
|
|
|
LOOSEN THE NUTS ON EITHER SIDE OF THE REAR AXLE, SLIDE IT FORWARD TO PUT SOME SLACK IN THE CHAIN. ONCE YOU HAVE THE CHAIN INSTALLED ON BOTH SPROCKETS, SLIDE THE AXLE BACK UNTIL THE CHAIN IS TIGHTENED PROPERLY AND THE WHEEL IS CENTERED. USE TYPE F AUTOMOBILE TRANSMISSION FLUID IN THE MOPED'S TRANSMISSION. THERE IS A SMALL PHILLIPS SCREW NEAR THE BOTTOM OF THE TRANSMISSION CASE, TAKE IT OUT, FILL THE TRANS. UNTIL OIL RUNS OUT THIS HOLE AND REPLACE THE SCREW. ----- Original Message ----- From: "David Rumsey" <bigd-@ufl.edu> Sent: Sunday, June 10, 2001 11:56 AM Subject: Moped Chain
|
| |
Message Index | |
